From Fedora Project Wiki
(Created page with "{{QA/Test_Case |description=This test case cover bonding two or more ethernet interfaces together. |setup= * Have LAN connection available, preferably with IPv4/IPv6 dualstac...") |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 7: | Line 7: | ||
# Connect all ethernet interfaces to same LAN. | # Connect all ethernet interfaces to same LAN. | ||
# In "nm-connection-editor" add new "Bond" connection and configure it by adding two or more existing interfaces. | # In "nm-connection-editor" add new "Bond" connection and configure it by adding two or more existing interfaces. | ||
# Select bonding mode "Active backup". Run {{command|ping ip.address.of.gateway}} and if you have IPv6 connection also: {{command|ping6 ip:address::of:gateway}} | # Select bonding mode "Active backup". Run {{command|ping ip.address.of.gateway}} and if you have IPv6 connection also: {{command|ping6 ip:address::of:gateway}}. Then physically disconnect and re-connect various interfaces in random (keep at least one connected). | ||
# Round-robin | # Round-robin | ||
{{admon/important|Work in progress, stay tuned!}} | {{admon/important|Work in progress, stay tuned!}} | ||
|results= | |results= | ||
# Using {{command|ip link show}} check if bonding is configured properly. "bond0" should has state "MASTER", physical ethernet interfaces should have state "SLAVE" and "master bond0" in their attributes. | |||
|optional= | |optional= | ||
* Go through [[QA:Testcase_NM_Ethernet|Ethernet]] test case for each bonding mode. | * Go through [[QA:Testcase_NM_Ethernet|Ethernet]] test case for each bonding mode. | ||
Latest revision as of 23:21, 9 December 2012
Description
This test case cover bonding two or more ethernet interfaces together.
Setup
- Have LAN connection available, preferably with IPv4/IPv6 dualstack support.
- Have two or more ethernet interfaces.
How to test
- Connect all ethernet interfaces to same LAN.
- In "nm-connection-editor" add new "Bond" connection and configure it by adding two or more existing interfaces.
- Select bonding mode "Active backup". Run
ping ip.address.of.gatewayand if you have IPv6 connection also:ping6 ip:address::of:gateway. Then physically disconnect and re-connect various interfaces in random (keep at least one connected). - Round-robin
Work in progress, stay tuned!
Expected Results
- Using
ip link showcheck if bonding is configured properly. "bond0" should has state "MASTER", physical ethernet interfaces should have state "SLAVE" and "master bond0" in their attributes.
Optional
- Go through Ethernet test case for each bonding mode.
- Test other bonding modes like: XOR, Broadcast, 802.3ad, Adaptive transmit load balancing, Adaptive load balancing