From Fedora Project Wiki
No edit summary |
No edit summary |
||
| Line 9: | Line 9: | ||
#:<pre>$ rpm -q pm-test-day</pre> | #:<pre>$ rpm -q pm-test-day</pre> | ||
|actions= | |actions= | ||
{{admon/note|This test needs to be run on battery.}} | |||
{{admon/warning|If your battery is charged to less than 50% of its capacity please re-charge it before this test.}} | |||
# Run the following command: | # Run the following command: | ||
#:<pre># pmtd-measure-powersave-idle</pre> | #:<pre># pmtd-measure-powersave-idle</pre> | ||
Revision as of 19:06, 20 March 2011
Description
This test case measures energy consumed by you system while in active idle with laptop-battery-powersave profile activated.
This test targets laptop users.
This test will take approx. 15 minutes.
If you do not have laptop or enough time feel free to skip this test. In this case please leave the corresponding column in the results table blank.
If you complete this test, please also complete the Tuned perf idle test.
Setup
- Check that you have pm-test-day package installed:
$ rpm -q pm-test-day
How to test
This test needs to be run on battery.
If your battery is charged to less than 50% of its capacity please re-charge it before this test.
- Run the following command:
# pmtd-measure-powersave-idle
- Do not touch your computer until the test completes (cca. 15 minutes).
- Write the output to the results table.
Expected Results
- Energy consumed during the test is written to the stdout.