From Fedora Project Wiki

No edit summary
No edit summary
 
Line 7: Line 7:
# From the dom0, disconnect the interface from the rawhide guest <pre>$> virsh detach-interface rawhide bridge [--mac <mac>]</pre> If you don't specify the mac address you may remove eth0 instead.
# From the dom0, disconnect the interface from the rawhide guest <pre>$> virsh detach-interface rawhide bridge [--mac <mac>]</pre> If you don't specify the mac address you may remove eth0 instead.
# Try adding at least 16 with something like this <pre>$> for i in `seq 1 15` ; do virsh attach-interface rawhide bridge virbr0 ; done</pre>
# Try adding at least 16 with something like this <pre>$> for i in `seq 1 15` ; do virsh attach-interface rawhide bridge virbr0 ; done</pre>
# Now you can repeat the steps but with type xenbr0, that is using <pre>$> virsh attach-interface rawhide bridge xenbr0</pre>. Note, this will require you configure the interface differently, possibly with dhcp. That's most easily done with the ifup/down scripts in /etc/sysconfig/network-scripts.
# Now you can repeat the steps but with type xenbr0 <pre>$> virsh attach-interface rawhide bridge xenbr0</pre>. Note, this will require you configure the interface differently, possibly with dhcp. That's most easily done with the ifup/down scripts in /etc/sysconfig/network-scripts.
|results=
|results=
# The network devices should be presented to the domU on attach-interface, and removed from the guest on detach-interface.
# The network devices should be presented to the domU on attach-interface, and removed from the guest on detach-interface.

Latest revision as of 20:45, 16 September 2009

Description

This test case verifies that Xen DomU networking works correctly, including the ability to attach/detach network devices.


How to test

  1. From the dom0, attach a new virbr0 type interface to the rawhide domU
    $> virsh attach-interface rawhide bridge virbr0
  2. Inside the guest run
    $> ifconfig
    You should be able to see it. It will probably be eth1, assuming you already had eth0 setup from installation.
  3. Trying pinging the gateway from it
    $> ifconfig eth1 192.168.122.10 netmask 255.255.255.0
    $> ping -I eth1 -c 2 192.168.122.1
  4. From the dom0, disconnect the interface from the rawhide guest
    $> virsh detach-interface rawhide bridge [--mac <mac>]
    If you don't specify the mac address you may remove eth0 instead.
  5. Try adding at least 16 with something like this
    $> for i in `seq 1 15` ; do virsh attach-interface rawhide bridge virbr0 ; done
  6. Now you can repeat the steps but with type xenbr0
    $> virsh attach-interface rawhide bridge xenbr0
    . Note, this will require you configure the interface differently, possibly with dhcp. That's most easily done with the ifup/down scripts in /etc/sysconfig/network-scripts.

Expected Results

  1. The network devices should be presented to the domU on attach-interface, and removed from the guest on detach-interface.
  2. The rawhide guest should be able to use the network interfaces.