From Fedora Project Wiki
(→Setup) |
|||
| Line 46: | Line 46: | ||
#* for testing in virtual machine do: | #* for testing in virtual machine do: | ||
<pre> | <pre> | ||
# | # virt-install --accelerate -n test-machine101 -r 1024 -f /var/lib/libvirt/images/test-machine101.img -s 21 -c Fedora.iso | ||
</pre> | </pre> | ||
Revision as of 14:02, 16 May 2013
Initial setup
- Prepare installation media available at {URL} according to instructions {URL}
- Optionally install virtualization support in Fedora:
# yum -y install @virtualization # service libvirtd start
Installation on bios/firmware RAID
Setup
- You need a machine with bios/firmware RAID supported by dmraid or MD. Linux MD driver supports Intel Matrix RAID technology, dmraid supports following products:
- asr : Adaptec HostRAID ASR (0,1,10)
- ddf1 : SNIA DDF1 (0,1,4,5,linear)
- hpt37x : Highpoint HPT37X (S,0,1,10,01)
- hpt45x : Highpoint HPT45X (S,0,1,10)
- isw : Intel Software RAID (0,1,5,01)
- jmicron : JMicron ATARAID (S,0,1)
- lsi : LSI Logic MegaRAID (0,1,10)
- nvidia : NVidia RAID (S,0,1,10,5)
- pdc : Promise FastTrack (S,0,1,10)
- sil : Silicon Image(tm) Medley(tm) (0,1,10)
- via : VIA Software RAID (S,0,1,10)
- dos : DOS partitions on SW RAIDs
- you need multiple hard drives connected to controller supporting RAID setup,
- setup arbitary RAID level in your firmware.
Action
- Boot the installation media on prepared machine,
- finish the installation by choosing default options.
Expected Results
- Installation starts up properly,
- RAID device is recognized and used,
- system is installed without issue, it boots up,
- system is installed on RAID and not underlying devices.
Cleanup
N/A
Installation on iSCSI
- Run any test case from QA:ISCSI_Installation_Test_plan
Default LVM with encryption
Setup
- Start installation from prepared media,
- for testing in virtual machine do:
# virt-install --accelerate -n test-machine101 -r 1024 -f /var/lib/libvirt/images/test-machine101.img -s 21 -c Fedora.iso
Action
- In INSTALLATION DESTINATION choose default layout with LVM,
- select encryption and put passphrase,
- complete the installation.
Expected Results
- Default partitioning layout is created,
- partitions are encrypted,
- installer asks for passphrase,
- system requests passphrase during boot,
- systems starts without issue with passphrase.
Cleanup
- To destroy virtual machine run:
# virsh destroy test-machine101 # virsh undefine --remove-all-storage test-machine101