Description
Setup required for the OpenStack Volumes. In the Folsom release of OpenStack, the nova-volume service was deprecated by the split out cinder service.
How to test
To create the cinder-volumes Volume Group for the openstack-cinder-volume service
sudo truncate -s20G /var/lib/cinder/cinder-volumes.img sudo vgcreate cinder-volumes $(sudo losetup --show -f /var/lib/cinder/cinder-volumes.img)
Because the volume service is dependent on the volume group being available,
it's not started by default, so to do that:
sudo systemctl start openstack-cinder-volume.service
Actions after each reboot
The above commands are not persistent across reboots, so please rerun these commands after reboot:
sudo losetup -f /var/lib/cinder/cinder-volumes.img sudo systemctl start openstack-cinder-volume.service
If you intend to make them persist automatically, then enable the service to start in the standard manner, but ensure that the losetup is run early in the boot process, or instead, use an implicitly persistent block device/partition.
Temporary workaround for packaging issue
In Folsom, the iSCSI target configuration files are dropped into /var/lib/cinder/volumes, so we need to ensure that these are picked up by the tgt daemon.
Prepend that directory to the tgt target configuration file:
sudo sed -i '1iinclude /var/lib/cinder/volumes/*' /etc/tgt/targets.conf
then restart tgtd:
sudo service tgtd restart
Expected Results
Check the volume group is listed by this command
vgs
Check that no errors are reported in /var/log/cinder/* or by this command:
sudo service openstack-cinder-volume status