From Fedora Project Wiki

Revision as of 14:55, 9 May 2021 by Imsedgar (talk | contribs) (chrony-wait.service must be disabled otherwise chronyd.service is started by this. Enable chrony again if it was before the test.)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Associated release criterion
This test case is associated with the Basic_Release_Criteria#system-service-manipulation release criterion. If you are doing release validation testing, a failure of this test case may be a breach of that release criterion. If so, please file a bug and nominate it as blocking the appropriate milestone, using the blocker bug nomination page.


Description

This test case tests whether starting, stopping, enabling and disabling system services works as expected.

Setup

  1. Perform an installation of the Fedora release you wish to test, making as few choices as possible and making the most obvious and simple choices where choice is required

How to test

Service used for testing
You may use another service for testing if necessary. Ensure it is a service which works reliably - this is a test of the service management mechanism, not of the particular service.
  1. Log in to the installed system
  2. In a console, run the following commands:
    sudo systemctl stop chronyd.service
    sudo systemctl disable chronyd.service
    sudo systemctl disable chrony-wait.service
  3. Now reboot. Log in again, and run the following commands:
    sudo systemctl status chronyd.service
    ps aux | grep chronyd
    sudo systemctl start chronyd.service
    sudo systemctl status chronyd.service
    ps aux | grep chronyd
    sudo systemctl stop chronyd.service
    sudo systemctl status chronyd.service
    ps aux | grep chronyd
    sudo systemctl enable chronyd.service
  4. Now reboot. Log in again, and run the following commands:
    sudo systemctl status chronyd.service
    ps aux | grep chronyd
    sudo systemctl disable chronyd.service
  5. Now reboot. Log in again, and run the following commands:
    sudo systemctl status chronyd.service
    ps aux | grep chronyd
  6. If chrony was enabled before starting the test, then enable and start it again.
    sudo systemctl start chrony-wait.service
    sudo systemctl enable chronyd.service
    sudo systemctl start chronyd.service

Expected Results

  1. Each time they appear, the commands sudo systemctl status chronyd.service and ps aux | grep chronyd check whether the service is running. The expected results, in order, are:
    Disabled and inactive (not running)
    Disabled but active (running)
    Disabled and inactive (not running)
    Enabled and active (running)
    Disabled and inactive (not running)