QA:Testcase Modularity enable-disable module

Description

This test checks the modular operations on a Fedora system.

Setup

1. To start and learn how to list modules, follow the instructions in this test case here

How to test

Enabling Modules on the system

By default, all modules are disabled. To enable a module, run the following commands to enable the module:

• dnf module enable module:stream enables a particular module stream.

Check, that the enabled module appears in the list of enabled modules and that the stream and profile match your selection. If you have not specified the profile, the default profile should be enabled.

Disabling Modules

To disable a module, you have to have enabled some of them. If there are enabled modules, try to disable them using the commands:

• dnf module disable foo:stream disables a particular module stream.

Check, that the disabled module appears in the list of disabled modules and that the disabled stream and profile of the module matches your selection.

Expected Results

All above commands execute without errors.

1. When you enable the module (:stream/profile), a confirmation "module:stream/profile is enabled" appears. The module must be on the list of enabled modules.
2. When you disable the module (:stream/profile), a confirmation "module:stream/profile is disabled" appears. The module must not be shown on the list of enabled modules.

Optional

Try various modules and streams/profiles.