QA:Testcase Anaconda User Interface Basic Video Driver

Description

A complete installation using the vesa driver for installation. Note that graphical install requires 768MB RAM (as of Fedora 16; will likely decrease for Fedora 17).

How to test

1. Boot the installer using any available means (DVD, netinst/boot.iso, Live or PXE)
2. At the initial screen, select Troubleshooting -> Install Fedora in basic graphics mode
3. Proceed with normal installation

Expected Results

1. The installer boot screen displays the option Troubleshooting -> Install Fedora in basic graphics mode
2. The graphical installer displays properly and uses the vesa driver. Confirm vesa driver usage by inspecting /var/log/Xorg.0.log, /tmp/X.log or /var/log/anaconda/anaconda.xlog. You should see output similar to the following:

   [    71.321] (II) VESA(0): initializing int10
   [    71.325] (II) VESA(0): Primary V_BIOS segment is: 0xc000
   [    71.326] (II) VESA(0): VESA BIOS detected
   [    71.326] (II) VESA(0): VESA VBE Version 2.0
   [    71.326] (II) VESA(0): VESA VBE Total Mem: 4096 kB
   [    71.326] (II) VESA(0): VESA VBE OEM: VGABIOS Cirrus extension
   [    71.326] (II) VESA(0): VESA VBE OEM Software Rev: 1.0
   [    71.326] (II) VESA(0): VESA VBE OEM Vendor: VGABIOS Cirrus extension
   [    71.326] (II) VESA(0): VESA VBE OEM Product: VGABIOS Cirrus extension
   [    71.326] (II) VESA(0): VESA VBE OEM Product Rev: 1.0

3. The installed system should contain a /etc/X11/xorg.conf or /etc/X11/xorg.conf.d/XX-somename.conf file which specifies the vesa driver in the Device section
4. When X starts on the installed system, it should be using the vesa driver. Confirm by checking /var/log/Xorg.0.log for similar output to the above from the installer